Image 3:
Locate the H6 Header
on BMB2 Motherboard. From the
rear of the chassis, BMB2 is on
the bottom left. The H6 Header is
highlighted.
For B16, jumpers must be on 1
and 8.
1
1. GETTING STARTED
1.1 Register
Please register all serial numbers for your B16 MOTHERSHIP chassis and all Daughter Cards.
You must register to activate your warranty! Please visit:
1.2 Install Daughter Cards (If Necessary)
If the Daughter Cards have been pre-installed, skip to page 3, step 1.8.
1.3 Remove Lid
1.
Remove 9 screws on top and 2 on each side (
Image 1
).
2.
Push lid up from card slot (
Image 2
).
1.
Find H6 on the BMB2 Motherboard, as shown in
Image 3
below.
2.
Jumpers should be on 1 and 8 for use with B16 MOTHERSHIP.
Image 2:
Push lid up.
Image 1:
Top view shows location of 4
screws on side before removing the lid.
1.4 Verify Jumper Settings On BMB2
