6
Getting Started:
1. Connect XLR cables to analog input.
2. Connect desired digital output (Dante, AES, SPDIF or Optical).
3. Connect Word Clock cables if clocking via Word Clock (clocking via Dante, SPDIF or AES is also possible).
4. Set clock to Int. or Ext. (Internal recommended whenever possible).
5. Set sample rate on front panel, when clock master.
6. Select Dual Wire On or Off.
7. Set input level. We recommend starting at -18 dbfs.
B2 Bomber ADC Signal Path
INPUT
BX1 Input
Transformer
Input Level
PIN 1
PIN 3
PIN 2
ADC
Figure 1
B2 BOMBER ADC
Getting Started:
1. Connect XLR cables to (analog) output.
2. Connect desired digital Input Source (Dante, AES, SPDIF or Optical).
3. Connect Word Clock cables if clocking via Word Clock
(clocking via Dante, SPDIF or AES is also possible).
Select Input Source.
4. Set clock to Int., Ext. or Digital In (Internal clock recommended whenever possible).
5. Set sample rate on front panel, when clock master.
6. Set Output Level.
Figure 2
B2 BOMBER DAC
B2 Bomber DAC Signal Path
OUTPUT
Attenuator
PIN 1
- PIN 3
+ PIN 2
DAC
BOPA1
BOPA1
