76
Troubleshooting with messages
19.3
Messages
: out of specification
→
If the message displayed on your product is not explained in the Operating Instructions, contact Bürkert.
19.3.1
Message
Error: too low pH
Product-status symbol
Bit status of the PDO pH-state
bit 5 = 1
Possible cause
The pH value of the water sample is is under the set limit.
The message can only be displayed if the monitoring of the pH
value has been configured and activated. Refer to chpt.
What to do?
→
Check the process.
19.3.2
Message
Error: too high pH
Product-status symbol
Bit status of the PDO pH-state
bit 4 = 1
Possible cause
The pH value of the water sample is is above the set limit.
The message can only be displayed if the monitoring of the pH
value has been configured and activated. Refer to chpt.
What to do?
→
Check the process.
19.3.3
Message
Error: too low temperature
Product-status symbol
Bit status of the PDO pH-state
bit 5 = 1
Possible cause
The temperature value of the water sample is under the set limit.
The message can only be displayed if the monitoring of the temper-
ature value has been configured and activated. Refer to chpt.
What to do?
→
Check the process.
19.3.4
Message
Error: too high temperature
Product-status symbol
Bit status of the PDO pH-state
bit 4 = 1
Possible cause
The temperature value of the water sample is above the set limit.
The message can only be displayed if the monitoring of the temper-
ature value has been configured and activated. Refer to chpt.
What to do?
→
Check the process.
English
Type MS01
Summary of Contents for Type MS01
Page 1: ...Operating Instructions Type MS01 pH sensor cube...
Page 86: ...86 English Type MS01...
Page 87: ......
Page 88: ...www burkert com...
