22
Technical data
Type 8098 FLOWave L
6.2.3
EHEDG certification
•
EL class I
•
The following device variants are EHEDG certified:
Process connections
Diameters
•
Clamp
1)
connections according to ASME BPE
(DIN 32676 series C)
•
3/8'', 1/2'', 3/4'', 1'', 1 1/2'', 2'', 2 1/2'', 3"
•
Clamp connections according to DIN 11864-3
series C
•
1/2'', 3/4'', 1'', 1 1/2'', 2''
•
Flange connections according to DIN 11864-2
series C
•
1/2'', 3/4'', 1'', 1 1/2'', 2''
•
Clamp
1)
connections according to
DIN 32676 series B
•
DN08, DN15 (except device variants with a clamp
diameter of 34.0 mm), DN25, DN40, DN50, DN65,
DN80
•
Clamp
1)
connections according to
DIN 32676 series A
•
DN08, DN15, DN25, DN40, DN50, DN65, DN80
•
Clamp connections according to DIN 11864-3
series A, DIN 11864-3 series B
•
DN08, DN15, DN25, DN40, DN50
•
Clamp
1)
connections according to SMS 3017 /
ISO 2852 for pipes according to SMS 3008
•
DN25, DN40, DN50
•
Flange connections according to DIN 11864-2
series A, DIN 11864-2 series B
•
DN08, DN15, DN25, DN40, DN50
•
External-threaded
2)
connections according to
DIN 11851 series A
•
DN65, DN80
1)
The EHEDG compliance is only valid if the process connections are used in combination with EHEDG-
compliant gaskets from Combifit International B.V.
2)
The EHEDG compliance is only valid if the process connections are used in combination with EHEDG-
compliant gaskets:
•
ASEPTO-STAR k-flex upgrade gaskets from Kieselmann GmbH, Germany
•
SKS gaskets set DIN 11851 EHEDG with EPDM or FKM inner gasket from Siersema Komponenten
Service (S.K.S.) B.V., Netherlands
→
To make sure you use EHEDG-compliant gaskets, refer to the "EHEDG Position Paper" available on the
EHEDG website.
The manufacturer of the device does not supply any gaskets for the process connections.
6.2.4
ATEX / IECEx certification
→
Refer to the ATEX / IECEx supplement for the device. The supplement is available at
English
