Burkert 8745 MFC Ethernet, Operating Instructions Manual

Page: 50 / 70

50
Setting and Operation
Type 8745 Ethernet, 8745 Analogue
10.3.2 Product variant Ethernet
•
All the product settings, including network parameters, can be
made with the Type 8920 Bürkert Communicator software.
→ To connect the product to the Bürkert Communicator
software, refer to chpt. 10.4 .
→
To get general information about the Bürkert Communi -
cator software, refer to the Operating Instructions for the
Type 8920.
•
The network parameters of the product can be set with the
product web server. The product web server can be used for
the following protocols:
-
EtherNet/IP
- Modbus TCP
→ To connect the product to the Bürkert web server and change
the network parameters of the product, refer to chpt. 8.4.
→
The web server is enabled upon product delivery. To disable
web server access , use the Bürkert Communicator software
and go to the menu
Web server parameter
Activate web server
•
Network parameters of the product can be set with any other
tool that is connected to the Industrial Ethernet network. The
tool must be compatible with the protocol that is active on the
product.
10.4 Connect the product to the Bürkert
Communicator software
To do the settings with the Type 8920 Bürkert Communicator
software, do the following steps:
→
Buy the USB-büS-interface set with article number 00772551
from Bürkert.
→
Download the latest version of the Type 8920 Bürkert Com -
municator software from country.burkert.com
→ Install the Bürkert Communicator software on a PC. During
installation, the büS stick must not be inserted at the PC.
→
Assemble the parts of the USB-büS-interface set. Refer to
Fig. 30 .
Fig. 30: Assembled parts of the USB-büS-interface set with article
number 00772551
→ Set the termination-resistance switch of the büS stick to ON.
→
Insert the büS stick into a USB port of the PC.
→ Energise the product. Refer to chpt. 8 Electrical installation .
English