147
LED Colour Assignments
21.2.3
Localisation function
For IO-Link and büS/CANopen devices only:
This function can be used to locate a device in the system via the controller or via the Bürkert Communicator.
However, the localisation function must be activated – see the respective device description file IODD (
“Process
output data”
) or EDS (
“Locating Function”
0x2101).
The device status LED (top LED) then starts to “flash” according to signal priority (see chapter “21.3”)
according
to the following logic: see
.
In
NAMUR mode,
the device status “single flashing” is displayed.
With
display modes “VM+F” and “VM+F+W”,
any error or warning messages that may occur are displayed
in the corresponding colour “single flashing” alternating with the corresponding position feedback (S1, S2,
S3 or S4)
– see
No. Flashing pattern
Note
Classic *)
NAMUR *)
VM *)
VM+E *)
VM+E+W *)
1
every second:
1 x 25 ms ON
single flashing:
in white: no (taught)
position
active
in colour from S1 or S2: S1 or S2 active
x
x
x
x
in colour of the device status
or in the error colour / warning colour
alternating with the position feedback (S1,
S2, S3, S4), if an error or warning message is
present
x
x
x
2
every second:
2 x 25 ms ON
double flashing:
in colour from S3: S3 active
x
x
x
x
3
every second:
3 x 25 ms ON
triple flashing:
in colour from S4: S4 active
x
x
x
x
Table 16:
Display behaviour during active localisation function
*)
These abbreviations mean: Classic –
device specific LED mode (8681 Classic Mode X),
NAMUR –
NAMUR mode (NAMUR NE 107),
“VM” –
Valve Mode,
“VM+E” –
Valve Mode with Error messages,
“VM+E+W” – Valve Mode with Error and Warning messages
english
Control Head Type 8681
Summary of Contents for 8681
Page 165: ...165 english Control Head Type 8681 ...
Page 166: ...www burkert com ...