Plus-X ICRU Installation and Operation Manual Rev B
4
Select “Use the following IP address:” and enter an address of the form 192.168.0.x, where x is
any value between 1 and 255 except 100 which is the Plus-X default IP address. Also set the
subnet mask to 255.255.255.0 as shown above.
Check the box “validate settings upon exit”
then click
OK
.
Now launch a browser and enter 192.168.0.100 in the address field. You will be prompted as
shown in the previous section to provide a password for the admin account, and then to log in to
the admin account using the newly assigned password.
Set a Static IP Address
The first screen displayed after initial login is the
Network
Settings
page, as shown below.
Enter a static IP address for this unit as assigned by your network administrator in the
IP
Address
box and click
Save
.
Note: It is important that the assigned static IP address be outside the DHCP address range
used by the router to avoid potential conflicts with other DHCP devices.
