8
INSTALLATION
The flowchart in Figure 3 shows the top-level installation steps for a single Plus-X VSWR. Step-by-step
instructions follow. This flow chart is intended to orient the user to the complete process. If you plan to
install more than one Plus-X VSWR system, perform this installation process separately for each Plus-X
VSWR. To prevent a possible network collision, do not plug a new Plus-X VSWR into your network until you
have entered the unique network settings for the last Plus-X VSWR system installed.
Figure 3. Overview of Plus-X VSWR installation procedure
UNPACKING
The Plus-X VSWR ships with the following:
•
Plus-X VSWR unit
•
Power cord
•
10’ shielded CAT5 cable
•
Six (6) 6-pin “Phoenix”-type plugs
•
Four (4) 9-pin “Phoenix”-type plugs
These parts will be needed for each Plus-X VSWR you plan to install. If any parts are not present when you
unpack the box(es), please contact Burk Technology Sales Department.
Start
Mount the Plus-X
VSWR unit(s) in their
rack space and apply
power
Unpack system and
inspect contents
Connect the first
Plus-X VSWR to your
LAN switch using the
ethernet cable.
Log-on to the Plus-X
VSWR:
<
User Name
>
<p
assword
>
Contact the Plus-X
VSWR for which you
just saved network
settings.
Repeat process for
each Plus-X VSWR
you wish to install.
Log-on to this Plus-X
VSWR unit for the
first time.
Enter & Record Plus-X VSWR Network Settings:
1. Unique hostname for your Plus-X VSWR
2. Static IP Address for your Plus-X VSWR
3. Network Subnet Mask & Gateway
4. IP Address of your ARCPlus system if
applicable
Save the network
settings and wait for
system to reboot.
Close the browser
window and re-open
a new window.
