Turning the appliance on / off .
.
If the appliance is in
Stand-By-Mode,
it is put in
Operating-Mode
by pressing
the
On/Off
button at least 1 second. A beep indicates a successful
operation.
On all heaters a ´0` appears and all
Decimal Point
of the heater flashes.
If there is no operation within 10 sec, the display of all heaters will turn off.
If the displays are turned of
f, the heater will be set to of
f.
If is pressed more than 2 sec (in
Operating-Mode
), the appliance is
switched off and is set into the off mode again. The appliance can be turned
off by pressing at any time; even if other buttons are pressed
simultaneously.
.............................................................................
If there is residual heat remaining, this will be indicated by a flashing H in
the corresponding
Heater
Display
.
Select Heater
.
If a single heater is chosen with the corresponding
Active/Deactive Heater
Button
, the
Decimal Point
of the related
Heater Display
flashes. For the
selected heater, you can set the heat level between 1-9 by touching the
Heat Setting Buttons
or .
.
The buttons must be pressed within 3 sec, otherwise the heater selection
is erased and heat setting dot will disappear (
Decimal Point
). If there is no
further operation within 10 sec, the heater falls back into of f mode.
The heat setting can always be changed by pressing or between
level 1-9.
.
Each button operation or each display change is accompanied by a beep.
8
Dual/Oval zone activation
. Touch the related zone selection key,
. Touch or key to adjust heating level.
. Then touch the dual/oval zone selection key.