B-Smart-Lock Keypad II | August 2018
01 - AN/ DSW | English |3
Dimensions
68,9 x 68,9 x 24 mm
Battery
lithium battery 3V, CR123A
Service life:
45.000 locking cycles
Permissible temperature 0°– 40°C
(no formation of condensation)
Protection class
IP 54
No. of possible codes
999.999
Code length
4 or 6 digits
Programming
Freely selectable PIN
Fixed assigned PIN
Material
Casing: plastic (RoHs proved)
Keypad: silicon
Keypad core: Zamak (zinc alumi-
nium)
Color
grey or user specific
Locking direction
L, R, LAD
Lock attachment
raised countersunk screw
5 x 16, Torx 20
Latch
plastic bolt
Technical specifications
Functional description
Master code
The master code starts off any programming process an can
re-enable a lock anytime. In Freely selectable PIN mode, the
PIN used to close is deleted once the master code has been
entered.
Freely selectable PIN mode
In this mode, the user can enter any PIN.The user must first
close the door. The user then enters a PIN of choice and enga-
ges the lock. The PIN entered is valid until the lock is opened
with the same PIN.
Fixed assigned PIN mode
In this mode, the PIN is stored in the lock. The lock only enga-
ges or disengages when the stored PIN is entered. Up to 50
PINs can be stored simultaneously. Each stored PIN can open
the lock, even it has been locked with a different PIN.
LED-locking status indicator
A red flash every second in the locking indicator indicates that
the lockis engaged. When open, the LED does not flash. This
function is optional and can be turned on or off as desired.
Code reenter
The verification code can only be used in Freely selectable PIN
mode. If a PIN is entered to engage the lock, it must be input
again, when the green LED flashes for a short time to confirm.
Only then does the lock actually engage. Simply enter the code
again to open.
Battery warning
The low battery warning is given in two stages. If the battery
capacity drops below the first level, the LED lights up red for
three seconds after a PIN is entered. If the capacity falls to a
critical level, the lock cannot be engaged at all and can only
opened with the master code.
Note: we recommend replacing the battery as soon as the red LED
gives the first warning.
Important information
Each step of the configuration is confirmed as completed
with a double flash of the LED. It is absolutely imperativ
to only begin the next step of the configuration after this
flashing signal.
If you switch from one mode to the other (Freely selectable
PIN
Fixed assigned PIN; Fixed assigned PIN
Freely
selectable PIN), all other functions are reset to the factory
settings.
Caution: This does not apply to the master code.
If the configuration step is completed incorrectly, the lock
signals this with 8 consecutive flashes of the LED.
Caution: the lock is disabled for 45 seconds after 3 wrong inputs. A
red flash every second indicates that the lock is currently disabled.
This disablement can be terminated early by entering the master
code.
The master code must always be entered as follows:
√ √ 1 master code √
e. g. √ √ 1 934 716 √
