Door eGuard
English |
2
Structure
Figure
Digital spyhole
Charge indicator lamp
1 attachment screw
4 x AAA batteries
Holding plate
Camera
Fastening sleeve
Tightening tool
· All rights reserved including any changes of product appearance,
technical function and usage without prior notice to users.
· Use of this product other than that for which it is intended for or
any modification to the original specification will invalidate any
guarantee given.
· Use of this product in any environment or in any way other than
specified here will also invalidate the guarantee.
Attention
1. Please read this user manual carefully before using our product.
2. Never attempt to repair or modify this product or its accessories by
yourself, to avoid injury and invalidating guarantee!
3. Any accidental factor such as being struck by lightning or any incorrect
operation could cause
a memory loss on the micro sd-card.
Keeping copies of the pictures is strongly recom mended in case of
memory loss. We are not responsible for any loss of data.
4. DO NOT use any chemicals to clean this product, such as alcohol or
benzene thinner.
5. Please change the batteries soon after the low-battery indicator shows,
in order to avoid any damage to this product which could be caused by
battery weeping.
Dear customer,
thank you very much for deciding for Door eGuard manufactured by
BURG-WÄCHTER. Door eGuard is a battery-operated system with a camera
and colour monitor, easy to install and providing its user with the certainty
of being able to see anything happening outside the entrance door without
being seen. Thanks to its large adjustment range, this door spyhole can
be used with any common door with a thickness from 38 to 110 mm. The
camera optics can cover existing holes in the door of 14 – 26 mm. Thanks to
the camera optics with a large viewing angle, even persons hidden near the
door can be identified.
Important: Please read the entire User Manual before you start to
mount the device.
Let us wish you a high level of security and
quality of living with your electronic spyhole.
Your BURG-WÄCHTER KG
Installation instructions
1. Fixing the camera on the outside of the door.
Replace the existing door position or drill a
14 mm hole at the desired position. Peel off the 3M protective film and
then guide the camera into the hole from the outside. Take care that the
cable is guided through the door without kinks. Make sure that the bell
push button is located under the camera and align the camera vertical to
the floor before fixing the camera to the door.
2. Attaching the monitor holder.
Release the monitor holding plate from the rear of the monitor by
unscrewing the screw on the bottom of the monitor using a screwdriver.
Peel off the 3M protective film from the rear of the holding plate and
guide the camera cable through the hole in the middle. Make sure that
the arrow on the holding plate points upwards before fixing the holding
plate with the 3M adhesive strip to the inside of the door. Pull the camera
cable through the fixing sleeve and screw this tight using the enclosed
assembly tool.
