7
THIS URN IS NOT INTENDED TO CONTINUOUSLY BOIL WATER, DUE TO THE HAZARDS OF STEAM
AND WATER ESCAPING FROM UNDER THE LID.
If it is necessary to keep the water at an exact temperature, use a thermometer to check. Stir the
water before taking the temperature and when the desired temperature has been reached, turn the
control knob slowly to the left until a click from the thermostat is heard. The thermostat will then
cycle on and off to maintain the temperature.
4.1.2 Safety tap
The tap is locked or unlocked by turning the tap lever so that either the closed or opened padlock
symbol is lined up with the white dot at the front of the tap body.
There are two open positions, one self-holding so that the tap remains open, and the other self-
closing so that the tap closes as soon as the lever is released. To change the tap position, turn the
tap lever through 180°.
Open the tap by depressing the lever tap to the horizontal position. Close the tap by returning the
lever to the vertical position.
4.1.3 After use
Turn the control knob to 0 and disconnect from the mains supply.
Water may be left in the urn when not in use for short periods, but to maintain a supply of fresh
water, it should be emptied periodically and cleaned out.
4.1.4 Protective Cutout
The heating element is fitted with a thermal cut-out which protects the urn from damage if allowed
to boil dry or switched on without water. It is essential to keep the heating element free from scale
to ensure correct operation of this cut-out. Scale can cause the cut-out to operate when water is
heating up normally.
If the cut-out operates, allow the urn to cool down, drain out any water then press the red reset
button situated under the base.
4.1.5 Cleaning
➢
ALWAYS TURN OFF THE POWER SUPPLY AND REMOVE THE PLUG BEFORE CLEANING, ALLOW
Knob setting
Approximate water
temp
1
37°C (99°F)
2
55°C (131°F)
3
68°C (155°F)
4
82°C (180°F)
5-6
97°C (207°F)