15
Laser Grader
Operation
5.4 Adjusting Receiver Plate
The receiver plate on the grader is designed to allow the operator to lower the boom all the way down
during normal operation and get a consistant pressure from the stabilizing roller.
To adjust the height of the roller from the ground.
1.
Attach grader to skidsteer.
2.
Lower grader on to a flat level surface, with the skid steer boom all the way down.
3.
Adjust bucket tilt until grader is relatively flat or parallel with the ground.
4.
Measure the distance between the bottom of the roller and the ground (A).
5.
If the roller is not at the desired height, detach the grader from the skid steer.
6.
Loosen the six bolts (B), but do not remove them.
7.
Loosen the two locking nuts (C) on the turnbuckles.
8.
Adjust the length of the turnbuckles to move the receiver plate into the desired position.
9.
Tighten the locking nuts (C) on the two turnbuckles, and tighten the six bolts (B).
10.
Recheck the height of the roller from the ground.
C
B
B
B
B
B
B
C
.25
A