Assembly
1
Step
Find a soft level surface for assembly (such as grass / mulch / bark chips), the larger the area
the better. Avoid assembling on hard surfaces such as brick / concrete as this may scratch the
paint of the climbing dome.
Take 2x green poles and 4x brown poles and lay them out as shown below.
P1
P2
Take 1x long bolt , 1x washer and 1x regular nut . Place washer on to
the long bolt .
With the bolt pointing up, starting with the bottom right brown (pole number 1 above) stack
each pole onto the bolt working in an anti-clockwise direction (1 then 2, then 3, then 4, then 5,
then 6).
Thread the regular nut onto the bolt and tighten firmly with the spanner and allen key so
the joint is firm and each pole stays in place (do not over tighten).
Note: Use the spanner to hold
the nut whilst using the allen key to turn and tighten the bolts.
You will end up with a 6 pointed star with the bolt head and washer on the inside (concave
side) and nut on the outside as shown in the pictures below.
Repeat the process above until you have 5 stars like the image below.
B1
W
N2
W
B1
N2
Page 4
Important
Ensure you tighten the bolt firmly in this step it
will make aligning the dome much easier in th
later steps.