Page 12
FRONT PANEL REMOVAL AND TANK DRAINING
Remove drip tray. Remove two screws.
Lower the panel as far as it will go.
Push the top down to clear the brew cham-
ber support arm, then pull the top out first.
Pull drain hose out as shown. Slide clamp
back and remove plug. Refer to program-
ming section and enter "Factory Blowout"
mode. Allow tank to drain into sink or
suitable container.
TANK DRAINING
RESET TO FIRST TIME SETUP
WARNING: DISCONNECT BREWER FROM POWER SOURCE BEFORE PANEL REMOVAL.
NOTE: If tank was drained, follow this procedure
before connecting brewer to power source.
Disconnect brewer from power source. Connect to
water supply. Install brew cup & chamber. Push and
hold both arrow buttons while plugging in the brewer.
When display reads "SET TO FIRST TIME UP", release
arrow buttons. Place a minimum 40 oz. container under
brew chamber. Press brew start button to begin cycle.
If tank was empty, it will expel only 20 oz. If tank was
still full, it will expel 40 oz.
42822.1 040810
WARNING
DISCONNECT BREWER
FROM WATER SUPPLY
BEFORE DRAINING
