Bunn-O-Matic Corporation
7
Setup and Programming
User Interface
The switch decal adheres to the front housing over the electronic switch and LCD (Liquid Crystal Display) board. The
mechanical switches are mounted directly onto the electronic board with a button mounted on the stem for product
actuation. The switch decal is nothing more than a overlay with description of the buttons. The user interface allows
the user to program the brewer for product recipes and begin the brew process with the selection of large or small
cup. The My Caf é AP brewer also gives the user the option of a Hot Water dispense.
Switch
Operation
“Programming”
Switch Operation “Operating Controls”
Programming Lockout Switch
The programming lockout switch is located on the main control board. This switch can
be set to prevent access to the programming settings of the brewer. Once all the cor-
rect brew settings are programmed, the operator can set the switch to the “On” position
to prohibit anyone from changing the settings. With the switch in the “On” position, the
programming menus can still be accessed to view the current settings. However, no
changes will be saved.
To access the lockout switch:
Step 1:
Disconnect brewer from power source before removing any panel.
Step 2:
Access the rear of the machine.
Step 3:
Remove the rear panel by removing six standard screws.
OPEN/CLOSE
This is used to open
or close the pod
holder door.
LARGE BREW
Preset but can be
adjusted.
HOT WATER
Push and hold for dis-
pensing hot water only
(Max 10 oz).
SMALL BREW
Preset but can be ad-
justed.
HIDDEN SWITCH
Step forward through
screens
OPEN/CLOSE
"NO" or (-)
LARGE BREW (A)
"DONE"
HOT WATER
"YES" or (+)
SMALL BREW (B)
Step backwards through
screens
HIDDEN SWITCH
Press until display reads
"BREW LOCKOUT"
St
Summary of Contents for My Cafe AP
Page 1: ...BUNN TECHNICAL TRAINING My Cafe AP ...
Page 34: ......
