5
PLUMBING REQUIREMENTS
This dispenser must be connected to a
COLD WATER
system with operating pressure between 20 and 90 psi
(138 and 620 kPa) from a
1
⁄
2
" or larger supply line. A shut-off valve should be installed in the line before the dis-
penser. Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to 50 psi (345
kPa). The water inlet fitting is
1
⁄
4
" flare.
NOTE -
Bunn-O-Matic recommends
1
⁄
4
" tubing for installations of less than 25 feet and
3
⁄
8
" for more than 25 feet
from the
1
⁄
2
" water supply line. At least 18 inches of an FDA approved flexible beverage tubing, such as reinforced
braided polyethylene or silicone, before the dispenser will facilitate movement to clean the countertop. Bunn-
O-Matic does not recommend the use of a saddle valve to install the dispenser. The size and shape of the hole
made in the supply line by this type of device may restrict water flow.
PLUMBING HOOK UP
1. Remove the shipping cap from the fitting on the rear
of the dispenser, Fig 3.
2. Attach the flare elbow fitting (supplied separately with
the dispenser) to the fitting.
3. Flush the water line and securely attach it to the flare
elbow fitting.
4. Turn on the water supply.
FIG 3
39338 040309
P3746
This equipment must be installed to comply with the International Plumbing Code of the International
Code Council and the Food Code Manual of the Food and Drug Administration (FDA). For models installed
outside the U.S.A., you must comply with the applicable Plumbing/Sanitation Code for your area.
CE REQUIREMENTS
• This appliance must be installed in locations where it can be overseen by trained personnel.
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specified in conformance with all local and national codes
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given instructions concern-
ing use of this appliance by a person responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
•
If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with
a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.
