4
GRIND ADJUSTMENT
1.
Place an empty bag on the tray, with the back of bag behind the dispense chute.
2.
Start the grinder to clean the grind chamber. Leave grinder "ON".
3.
Turn the Grind Selector knob to the "O" (ESPRESSO) position.
4.
Use a small flat blade screwdriver to loosen the two set screws located on the grind selector knob.
5.
Hold the knob in the "O" position with one hand.
6.
Using a large flat blade screwdriver, slowly turn the large adjusting screw in the center of the grind selector
knob to the right (clockwise) until a metallic whine is heard.
7.
While holding the knob in the "O" position, back off the screw to the left (counter clockwise) just until the
metallic whine ceases.
8.
Turn off the grinder.
9.
Tighten one set screw in the grind selector knob.
10. Turn knob to the "2" position.
11. Holding the knob in the "2" position, loosen set screw tightened in step 9.
12. Holding a large flat blade screwdriver on the large adjusting screw to prevent it from turning, turn the knob
back to the "O" (ESPRESSO) position, then tighten both set screws.
CLEANING
The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment. Regular cleaning will keep your grinder looking new for years.
SCHEMATIC WIRING DIAGRAM
HVG
208-240 VOLTS AC
3 WIRE
SINGLE PHASE
60 HZ
GRN
L1
N
ON/OFF SW
MOTOR
D
E
F
L3
L2
L1
L2
BLK
BAG SW
BLK
K
BLK WHI
RED -12
T2
L2
FAN
WHI
T1
L1
BLK -12
BLK
MOTOR TEMP SENSOR
BRN -12
BLU-12
MANUALLY
RESETTABLE
MOTOR THERMAL
PROTECTOR
1
3
BLK -12
C A P
RUN
C A P
STARTING
VIO -12
BLU -12
RED -14
WHI -14
BLK
10899 060100
