INSTRUCTIONS FOR USE
Insert knife
in slot
• Pull back on the red-capped Lock Lever to unlock the Clamp
Arm. Pivot the Clamp Arm to the full-open position.
• Set insulation on the lower Clamp Bar so that the cutting slot
is in-line with the desired cut.
1
1
2
2
• Close the Clamp Arm to compress the product, pressing
down until the Lock Lever engages.
• Insert the EZ Insulation Knife (included) into the cutting
slot on the Clamp Arm.
• Cut through the insulation product with a sawing motion,
drawing the blade toward you.
PRT-INS-1901 RevC.5.15 ©2015 Bullet Tools
For warranty info, accessories, & tips on using and
maintaining your Shut-N-Cut, go to BulletTools.com
Hayden, ID USA • 208-772-0175
Clamp Pressure Adjustment
1) Remove the wingnuts.
2) Move the spring-rest pins to the desired setting.
For very low pressure, remove the pins completely.
3) Replace the wingnuts.
wingnut
wingnut
SAFETY
1)
SHARP BLADE
- This machine uses
a razor sharp blade.
Keep hands, feet, and other
appendages away at all times.
2) Wear Kevlar™ or cut-resistant
leather gloves when operating or
servicing the blade.
3) This machine has several pinch
points. Do not adjust or collapse
machine when fingers are in the
way.
4) To avoid tipping and/or rocking,
only operate on a level, stable, flat
surface.
5) Wear safety goggles and all other
OSHA recommended safety gear
when cutting.