(5)
2.1 Attach the Power Cord
2.2 Install the Brush or Pad Driver
The triple-wire grounded power cord has been
factory-installed into the handle tube. Plug the male
connector (9) coming out of the motor housing into
the female connector (10) coming out of the end of
the handle tube.
Now, plug the end of the 50 foot power cord into a
grounded power outlet.
queeze both triggers on the handle
and check for power to the motor.
Your floor machine has been built with a “B” style
drive plug fixed to the motor shaft. A brush or pad
driver mounts onto the machine using a
“B” style or a “ Universal” plate on the
brush block
Unplug the floor machine. Lock the
machine handle in the “up” position
and tip the floor machine back
onto the handle.
Mount the brush or pad driver with
the clutch plate(11) over the
drive plug (12).
Give the brush a quick spin to lock the brush
onto the floor machine.
Now, lower the machine back onto the brush.
You’re ready to go to work.
Push the red safety interlock
switch forward to unlock the dual triggers. Hold the
handle firmly, s
!
!
!
!
10
12
11
9
(4)
This floor machine is shipped from the factory with the handle
unattached. You will need two 7/16” wrenches to complete the
assembly.
Remove the handle and mounting hardware from its carton. Bolts,
nuts, washers and the locking lever assembly are in the plastic bag
attached to the handle.
Align the handle with the yoke (1) over
the mount (2) on the buffer chassis. The
power cord will be facing the motor.
Place a flat washer (4) on a 3” bolt (3),
then place the bolt through the holes in
the yoke and the mount. Place another
washer on the bolt and secure with the
locking nut (5).
Tip the handle up. The handle mounting
collar (7) is designed to slide freely up and
down the handle tube, allowing the handle
to be adjusted for the comfortable
operation of all users. Line up the
mounting collar with the upper holes in the
two bent handle braces (6).
1.
Mount the handle on the chassis.
2.
Mount the support braces to the
handle.
Place the curved spacer (12) with a
square hole onto the locking lever shaft
(11). The curve must face the lever, as in
the picture at right.
Insert the shaft through the upper hole in
the left handle brace (6), mounting collar
(7), and right handle brace.
Place a spacer (9) on the shaft.
Place the split washer (10) on the shaft
Place the locking wing nut (13) on the shaft.
Tighten and adjust the wing nut. When correctly installed, the
collar slides easily when the cam-engineered locking lever is
“up”, but is firmly fixed when the lever is “down”.
!
!
!
!
!
!
3
1
1
4
4
2
2
5
13
10
7
11
6
9
12
2.0 Mount the Handle
