4
9
PASSKEY (VATS) INSTALL ATION
(GM only. cont.)
STRIPE wire on the remote starter that ............
is connected to the starter/crank wire on .....the
ignition switch harness.
8. The PURPLE and the GREEN wires are not
used and should be taped up.
9. Put the key in the ignition switch and start ..the
vehicle with the key.
10.
.......
Wait until the L.E.D. light on the 791 goes
out. (See page 9 for LED placement.)
11. Turn off the vehicle the system has learned
the resistor value.
NOTE: If the light does not illuminate on the 791
when you first plug it in, you need to erase the
memory. See page 10.
Never cut, or probe into a small yellow tube as
NOTE: Do not plug the WHITE loop connector into
the module unless your vehicle is equipped with
a transponder system.
1
2
VATS
White or (Purple)
White
These wires will be
very small in
diameter.
MODEL 791
Y
ellow
Orange
Ignition
Switch
TRANSPONDER INSTALLATION
Ford, Chrysler, all imports and some GMs
labeled “ignition negative” or the YELLOW
wire and sometimes the YELLOW WITH
BLACK STRIPE wire marked “security
bypass out”.
5. Attach the ORANGE wire to ground.
All other wires on the module are not
used. Tape the ends.
6. Plug the loop wire into the white plug inside
the module.
7. When bypassing GMs transponder
(PK3), attach the RED wire not to +12v
constant, but to the heavy gauge
YELLOW WITH BLACK STRIPE wire
from your remote starter that is
connected to the starter/crank wire
on the vehicle.
8 Position Harness
Connector
Ignition Switch
Place the transponder loops
around the ignition switch as close
to the pick up coil or key hole end
as possible.
Extra ignition key.
Place inside the black
loop.
Once key is in place
and transponder loop
is plugged in, snap
both halves of Module
791 together.
Transponder Loop Plug
Red L.E.D.
Secure the loop with a
small wire tie around the
cylinder.
