Bullard TI Commander™ Thermal Imager
User Manual
P
alm and T
op Str
aps
5
Palm and Top Straps
The palm and top straps
(Item 12, 13, Figure 1)
are
designed to allow the user to replace the top and side strap
without having to return the unit to the factory.
Replacing the Palm Strap
Using a 3/8" wrench, remove the nut on the right side of
the strap. Remove the strap from the screw by lifting away
from the camera. Remove the left side of the strap by
removing the screw with a Phillips screwdriver. The new
strap should be attached by first securing the left bracket
to the camera using the existing screw. The right bracket
should then be secured by placing the bracket on the screw
and tightening the nut. The strap is correctly attached when
the Bullard logo or custom lettering is facing outward.
Adjusting the Palm Strap
To adjust the palm strap on the side of the unit, pull open the
leather hand guard and readjust the strap. Once adjusted to
comfortable length, close the leather hand guard.
Adjusting the Shoulder Strap
To attach the shoulder strap, clip the hooks to any of the
three D-rings on the unit. Adjust the strap to a comfortable
length.
Replacing the Top Strap
Unwrap the leather pad from the strap to expose the ends
of the strap. Remove the right side of the strap from the
Velcro. Wrap the end around the anchor on the top of the
camera and re-attach to the Velcro. Remove the left side of
the strap from the Velcro, wrap the end around the anchor
on the top of the camera and re-attach to the Velcro. Wrap
the leather pad around the strap ends.
Wrist Strap
This strap can be used as a backup to keep the imager from
falling if it should slip from your hand. The adjustable strap
fits over the sleeve of your turnout gear and can adjust to
any size wrist. The wrist strap can be easily attached to any
D-ring located on the camera.
Top Strap
Palm Strap
Wrist Strap
