Bull Cedoc Bull Escala 2104 TS4, Installation Manual

Page: 46 / 87

Connecting the 2104 Model TS4 to the power source
Perform the following steps to connect the 2104 Model TS4:
1. Ensure that the dc on/standby switch
1
on each fan-and-power-supply
assembly is set to standby. See Figure 29.
2. At the back of the 2104 Model TS4, plug a power cable into the mainline power
connector
2
on each fan-and-power-supply assembly.
3. Perform the grounding checks described in the Expandable Storage Plus: 2104
Model DS4 and Model TS4 Service Guide .
4. Plug the other end of each power cable into a mainline electrical power outlet. If
the power outlet has a switch, switch it on. The green ac pwr light comes on.
5. Switch on the dc on/standby switch
1
on each fan-and-power-supply
assembly. If option switch
5
(see Figure 22 on page 11) is on, the green dc
power light
3
comes on. See Figure 29. If option switch
5
(see Figure 22 on
page 11) is off, the green dc power light (see Figure 29) stays off. It will come
on when the 2104 Model TS4 is connected to the host system.
6. Go to “Connecting the 2104 Model TS4 to the host system” on page 19.
SC000047
Figure 29. Connecting power cables
18
2104 Model TS4 Installation Guide