compatible connector (e.g. Meanwell GST280A-C6P), just plug it directly into the power
connector.
Turn on the “Enable” switch
Plug in the power supply and turn on the “Enable” switch. The controller LCD screen will
illuminate. When “Ready” appears in the upper left corner, it is ready to operate.
Jog motors (if gamepad attached)
Use the joysticks on the gamepad to move the motors.
Connect via web browser
Open a browser on a computer that is connected to the same local network as the controller.
Then, enter “bbctrl.local” in the address bar.
Configure motors
Access the configuration screen by selecting the motor label in the left panel of the web page.
Motor 0 is associated with the port labeled “
X
” on the back of the controller. Motor 1 is labeled
“
Y
”, motor 2 is labeled “
Z
”, and motor 3 is labeled “
A
”.
