Buhler 2895E, Operator And Parts Manual

Page: 18 / 46

bühler
Allied Front-End Loader
- 16 - P4493
When loading bales onto a trailer, park trailer
in close proximity to minimize turning angle
and length of travel to increase loading
efficiency.
As you lift the bale using the regular loader, it
is recommended to feather the valve to allow
bucket cylinders to extend to keep bale at
about a 20
q
angle. (On TSL loaders this is
not necessary) Lift the bale only enough to
clear the area that the bale will be placed on.
Always approach the trailer square to the
tractor as shown.
CAUTION
Avoid sudden stops and sharp turns. Avoid uneven terrain areas for loading and
unloading.
After setting the bale down position the A –
frame with spear(s) horizontal to the ground
and slowly back the tractor straight out.
With pallet forks level and just above the
ground, drive the forks into the pallet
completely. Raise loader to lift pallet and
carry level 6 to 12 inches off the ground.
Note:
The TSL loader is highly
recommended when operating with pallet
forks for maintaining a constant level load.
Use the level indicator as a guide to ensure
forks are level at ground.
CAUTION
Avoid sudden stops and sharp turns. Operate at low ground speeds. Never
attempt to lift loads heavier than the rated fork specs (42”– 2200 lbs.) (48”– 4400
lbs.). Always lift or carry pallets using both forks and utilizing the full length of the
forks.
WARNING
When driving amongst livestock keep bucket cylinders retracted, and loader
boom at least 6 to 7’ off the ground. Store A – frame away from both play and
heavy traffic areas.
Level indicator