A Division of Vcom MM Corp.
South Hackensack, NJ 07606, USA
Tel.:(800)631-0868
If any parts or hardware are missing or damaged,
Do Not
Return
the unit to your dealer. Call the Buhl helpline at
(800)742-5672 for immediate parts replacement.
5.
In order to have the unit properly
aligned, stand unit upright on a
level surface. Gently rock unit
back and forth to realign and
level the unit.
TIGHTEN ALL
NUTS AND BOLTS WITH
WRENCHES AT THIS TIME.
Unit should now be properly
aligned and level. If unit is not
level at this time, repeat the
above steps before proceeding
to step 6.
6.
Lay unit on floor.
Insert casters
with brakes into
opposite corner
holes on the
bottom of the
unit as shown.
Insert the other
casters into the
remaining holes.
7.
Insert the two supporting poles onto the holes on top shelf. Wire
holes face inside.
Top horizontal mount
Bottom horizontal mount
8.
Insert the two horizontal
mounts onto the supporting
poles. Note: The mount with
adjustable screw(see screw
table H) should go on the
bottom. Screw(see screw
table G) the top mount to
desired height from A to F.
Adjust the bottom mount
height according to the TV
screw position as shown.
9.
Tighten the two supporting poles onto the top shelf with two
security screws as shown (see screw table F).
10.
Electrical bracket assembly instruction
A. Push power cord into cord winder bracket.
B. Attach electrical bracket to back side of top shelf with two nuts
and bolts(see screw table E). Tighten nuts and bolts securely.
Wrap power cord around wings of the bracket.
11.
Use the appropriate security screw needed (M4, M5, M6 or M8,
see screw table A,B,C or D) to fasten the flat panel TV onto the
horizontal mounts as shown.
Page 2
13.
Handle assembly instruction
( Optional )
A. Unscrew the scews from the handle.
B. Attach the handle to the top shelf (either side) and tighten
handle to the shelf with screws from the inside under the shelf
as shown.
12.
P
ull out shelf assembly instruction
Adjust the length of the pull out
shelf as shown on Fig. A by
loosing the screws and
tightening again so that the
width of the pull out shelf
matches the width of the
cart. Tighten the pull out
shelf to the cart with the
screw (see screw table J)
as shown on Fig. A and
Fig. B.
Fig. A
Fig. B
