Buffalo HD-QLU3R5, User Manual

Page: 33 / 360

32 HD-QLU3 User Manual
‣
․
…
‥
ÐÏ×ÅÒ
Troubleshooting
The DriveStation indicates errors with beeps and LED flashes. These beeps and flashes can help you
troubleshoot problems.
Access LED Status Beeping DriveStation Status
ー Repeated beeps
The fan on the back side is stopped. Turn off the
DriveStation and check if dust has accumulated on the
fan. If removing dust does not solve the problem, the fan
may be broken. Contact the Buffalo Technology Support
Center.
ー
One long,
continuous beep
A hard drive has overheated. Check if the fan on the back
side is running.
If the fan is not running, turn off the DriveStation and
check if dust has accumulated on the fan. If the fan still
does not run after removing dust, it may be broken.
Contact the Buffalo Technology Support Center.
If it is running, the hard drive may have failed. Check the
access LED to confirm the hard drive status. A hard drive
still may have overheated even if no access LED for either
hard drive is lit red. Turn off the power, and wait at least
one hour before using again.
One access LED is
glowing red
Beeps for about
three seconds and
stops
An error occurred in the hard drive. Replace the hard drive
whose access LED is lit. If replacing the hard drive does not
solve the problem, check if the hard drive is connected
correctly.
Access LEDs
These indicate the status for each internal
hard drive of the DriveStation. The number
next to the LED corresponds to the hard
drive number.
Power LED
This is lit when the power is turned
on and during RAID maintenance.
Beep