Buffalo DriveStation HD-CX1.0TU2, User Manual

Page: 5 / 132

4 HD-CXU2 Series User Manual
* Mac OS X may not recognize this device at boot. If this happens, unplug the USB cable, then plug it
again after a few seconds.
* If using Windows 2000, the “new hardware is found” wizard may be displayed during setup. If so, click
[Finish] to close the screen. The message "The software for this device is installed, but your device
may not work properly” is displayed. However, the unit should work properly.
* If your Windows computer will not boot while this drive is connected, then connect the drive to your
computer after rebooting Windows. Also, refer to your computer's manual to change the BIOS setting to
boot from an internal hard drive if you want to turn on or off your computer while this unit is connected.
* This unit supports hot-plug. You can plug or unplug the USB cable while this unit or your PC is ON.
However, NEVER unplug the USB cable while the Power/Access light is flashing, or your data may be lost
or damaged.
* Always refer to the manuals for your computer and peripheral devices.
* You cannot boot an OS from this unit.
* Do not lean any object against this unit.
It may cause the unit to malfunction.
* If you use this unit with Windows Vista or XP on a computer with a USB 1.1 port , you may receive
a message indicating that a high-speed USB hub is connected to a non high-speed USB device. To
continue, click "X".
* You may hear some noise while this unit is working, especially while booting or being accessed. This
is normal.
* On Windows 2000, the message “Warning: Improper Device Removal” will be briefly displayed after
you enter the password, but the device is working properly.
* When the driver for this unit is installed, devices are added to Device Manager(*).
To display Device Manager, follow the instruction below:
On Windows Vista .................................. Click "Start", right click "Computer", and click "Manage". When "A program
needs your permission to continue" is displayed, click "Continue" and click
"Device Manager".
Windows XP ............................................. Click "Start" and right click "My Computer".
Click "Manage" and then "Device Manager".
Windows 2000 ........................................ Right-click "My Computer", click "Manage" and then "Device Manager".
OS Location to be added Device name to be added
Windows Vista
Universal Serial Bus
controllers
USB Mass Storage Device
Disk Drive BUFFALO HD-CXU2 USB Device
DVD/CD-ROM Drive BUFFALO Virtual CD ROM USB Device
Windows XP/2000
USB Controller USB Mass Storage Device
Disk Drive BUFFALO HD-CXU2 USB Device
DVD/CD-ROM Drive BUFFALO Virtual CD ROM USB Device