Buffalo Tools LST30, Instruction Manual

Page: 8 / 33

LST30 30 Ton Log Splitter 8
Page 9
Flammable Gasoline: This log splitter may emit highly flammable and explosive gasoline vapors, which can cause severe burns or
even death. A nearby open flame can lead to an explosion even if not directly in contact with gasoline.
• Do not operate this log splitter near open flame.
• Do not smoke near this log splitter.
• Always operate this log splitter on a firm, level surface.
Gasoline is highly flammable and explosive. Handling fuel can result in serious injury or burns.
• Always shut down this log splitter before refueling. Refuel in a well-ventilated area. Keep heat, sparks and flame away while refueling and away
from the location where gasoline is stored. Never refuel indoors where gasoline fumes may reach flames and/or sparks.
• Allow this log splitter to cool for at least 2 minutes before removing the fuel tank cap. Loosen the cap slowly to relieve pressure in the fuel tank.
Avoid spilling fuel.
• Do not fill the fuel tank above the upper limit line. Gasoline may expand during operation. Do not fill to the top of the tank.
• Always check for spilled gasoline and immediately wipe it up before starting this log splitter.
• Empty the fuel tank before storing or transporting this log splitter.
• Always handle fuel outdoors.
• Before transporting, turn the fuel valve to the “OFF” position and disconnect the spark plug.
ASSEMBLY & SET-UP INSTRUCTIONS
WARNING! Use extreme caution unpacking this machine. Some components are very heavy and will
require additional people or mechanical handling equipment.
NOTE: All references in this manual to the left or right side and front or back of the log splitter are from the
operating position only. Exceptions, if any, will be specified.
UNPACKING THE CONTAINER
Step 1: Use a 14mm wrench to remove all the bolts and washers on the metal crate, put aside the packing top
and side frames, then remove the cardboard box.
Step 2: Remove all loose parts included in the container, including operator’s manual, wheels, hardware box and
engine box.
Step 3: Use scissors or a knife to cut and remove the straps securing the parts to the beam or tank assembly,
including fenders, tongue assembly, log tray & log dislodger assemblies, then put aside these parts for assembly.
NOTE: DO NOT remove the strap securing the hydraulic hoses assemblies to the beam at this time, until you
do the assembly procedure of the hoses.
Step 4: Use a pry bar or claw hammer to remove the plywood splinters securing the beam and tank assemblies
on the crate bottom. Take out the two assemblies.
Step 5: Inspect all component assemblies, parts and accessories according to the packing list.