COJSAWBX Electric Jig Saw Assembly & Operating Instructions
5
LADE INSTALLATION
ng the saw blade, make sure the power cord is unplugged.
Failure to do
ry or electric shock.
e is
nto the
ller,
B
Before installing or replaci
o could result in serious inju
s
Blades that do not properly fit will cause loss of control.
Always use the proper blade for this saw.
Before cutting, double check the tightness of the blade.
Serious injury could occur if the saw blad
ot securely in place.
n
t (A) by using the hex wrench.
1. Loosen the Hex Bol
2. With the blade teeth facing forward, insert the
blade into the side of the blade holder (B) with the
dot (the opposite side of the hex bolt).
The notch at the end of the blade should rest on
the roll pin.
3.
4. Tighten the hex bolt with the hex wrench.
5. Make sure the back edge of the blade fits i
Roller (C). To adjust the position of the Ro
loosen the base adjustment Bolt (D)on the
underside of the saw. Tighten Bolt before
plugging in the saw.
AW OPERATION
S
Wear safety eyewear and dust filters or respirators while using this tool.
Always keep both hands on the handles. This will ensure they are safe from the cutting path
of the blade.
Before beginning, make sure there is plenty of space below the work piece for the saw blade to pass freely.
t.
use undesired cuts or blade
e the trigger lock, squeeze the trigger again.
Hold the saw firmly, with one hand on the front grip and the other on the top handle. Be sure the power cord
nd any extension cords are out of the cutting path. If both hands are on the saw, they are free from the path
a
of the blade. Place the edge of the base against the piece to be cut, keeping the saw blade from contacting
the work piece. Use a cutting guide for maximum control when making straight cuts. Keep the base of the
saw against the work piece. Relief cuts can assist in making more difficult cuts.
Squeeze the trigger to start the blade moving. Allow the blade to reach full speed before attempting your cu
dvance the tool slowly when cutting curves or scrolling. Forcing the tool may ca
A
breakage.
This saw is equipped with a trigger lock. To engage the trigger lock, pull the trigger and press the trigger lock.
To disengag
Hex Bolt (A)
Roller (C)
Blade is Inserted Here (B)
Bolt (D)
