Buffalo Tools Black Bull DP16UL, Assembly & Operating Instructions

Page: 14 / 18

DP16UL 16 Speed Drill Press Assembly & Operating Instructions
14
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model. Accessories that may be
suitable for one tool may become hazardous when used on another tool.
Always attach grounded (3-prong) extension cords to grounded (3-prong) outlets.
If you must use an extension cord, be sure that the gauge is large enough to carry the amount of current
necessary for your power tool.
If not, your tool may experience a loss of power, excessive voltage drop or
overheating. For example, the smaller the gauge number, the heavier the cord.
TROUBLESHOOTING
Noisy? Review the probable cause and remedy:
A) Incorrect belt tension A) Adjust tension operation
B) Dry spindle B) Remove spindle / quill assembly and lubricate
C) Loose pulley lubricate C) Tighten Pulley
D) Worn bearing D) Replace bearing
Excessive drill wobble? Review the probable cause and remedy:
A) Loose chuck A) Tighten by pressing chuck down on to
a block of wood against the table.
B) Worn spindle or bearing B) Replace spindle shaft or bearing
C) Worn chuck C) Replace chuck
D) Bent drill bit D) Replace drill bit
Motor won't start? Review the probable cause and remedy:
A) Power supply A) Check power cord/fuse start
B) Motor connection B) Check motor connections
C) NVR switch connections C) Check switch connections
D) Faulty Switch D) Replace switch
E) Motor Windings Burned E) Replace Motor
Drill Bit Binds in Workpiece? Review the probable cause and remedy:
A) Excessive Feed Pressure A) Apply less pressure
B) Loose Belt B) Check Belt tension
C) Loose Drill Bit C) Tighten drill bit with key
D) Incorrect drill speed D) Refer to Cutting Speed chart, and
adjust drill speed accordingly
Table difficult to raise? Review the probable cause and remedy:
A) Needs lubrication A) Lubricate with light oil
B) Table lock tightened B) Loosen clamp