7
Router functionality is disabled.
3
Power LED (Green or Red)
On (Green):
Power is on and wireless LAN is enabled.
Blinking (Green):
Internal system is booting.
Double blinks (Green):
AirStation is waiting for an AOSS or WPS security key.
Slow blinks (Green):
Power is on but wireless LAN is disabled.
Continuously blinking (Red):
AOSS/WPS error; failed to exchange security keys.
Blinking (Red):
You can see the status as below:
Blinking
Status
Meaning
Double*
Flash ROM error
Cannot read or write on the flash memory.
Triple*
Wired LAN error
Wired LAN controller has crashed.
4 times*
Wireless LAN error
Wireless LAN controller has crashed.
5 times
IP address setting error
Cannot communicate because WAN-side and LAN-side
IP addresses are same. Change LAN-side IP address of
the AirStation.
Continuously**
Updating firmware
Backing up or initializing settings
Updating firmware.
Backing up or initializing settings.
Notes:
* Reconnect USB cable. If it blinks again, please contact your vender.
** Do not disconnect USB cable while continuously blinking (red).
4
AOSS Button
To initiate AOSS, hold down this button until the wireless LED flashes (about 1 second). Then, push or click the
AOSS button on your wireless client device to complete the connection. Both devices must be powered on for this
to work.
5
Reset Button
To reset all settings, hold down this button until the Buffalo LED turns red (about 3 seconds). The power must be
on for this to work.
6
Internet Port
10 Mbps and 100 Mbps connections are supported.
7
Factory Default Label
Displays AirStation’s SSID, encryption key, PIN and MAC address.