Page 6 of 8
——
1
2
3
4
5
6
7
8
9
0
Terminal Definition
Terminal pins assignment:
V+
Connect power “(RED)
N/A
N/A
V-
Connect power supply”-“(GREEN)
N/A
N/A
N/A N/A
N/A N/A
N/A N/A
GND GND of CAN(DEV)
T(+)
DEV data signal “Higher Voltage”
T(-)
DEV data signal “Lower Voltage”
2.3 Install Methods
1. Switch off all power supply before installation.
2. Connect the local “TX” Fiber Optic to the remote “RX” Fiber Optic, the local “RX” to the
remote “TX”. And ensure that fiber is properly aligned to the receiving connector.
3. Connect the “T+” Data of the modem to the “CANH” of the DeviceNet, and the “T-” Data
to the “CANL” of the DeviceNet. Then screw down the bolt.
4. On the bottom of the Modem, there is a DIP Switch.
DIP Switch setup table:
DIP Switch pin name
D1
D2
D3
D4
D5
Setup State
OFF
OFF
OFF
OFF
OFF
