Buell XB 2010, Service Manual

Page: 207 / 714

2.30
FRONT MODULES: LIGHTNING AND ULYSSES
MODELS
REMOVAL
1. Remove seat.
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
2. Disconnect battery cables from battery: negative cable
(black) first. See
1.16 BATTERY MAINTENANCE .
3. Remove windshield and windscreen. See 2.48 WIND-
SHIELD AND WINDSCREEN: LIGHTNING AND
ULYSSES MODELS
.
4. Remove headlamp assembly and support bracket. See
2.26 HEADLAMP ASSEMBLY AND SUPPORT BRACKET .
5. Disconnect and remove instrument module.
6. Ulysses Models: Disconnect and remove the auxiliary
power outlet.
7. See Figure 2-173 . Ulysses Models: Remove upper
module fasteners and remove upper module.
8. Remove ignition switch. See 6.3 IGNITION/HEADLAMP
KEY SWITCH .
NOTE
See Figure 2-172 . Once the ignition switch has been removed
there will be two remaining fasteners.
9. Disconnect front turn signals. See 6.14 FRONT TURN
SIGNALS .
10. See Figure 2-172 . Remove fastener attaching p-clamp to
rear side of right front module.
NOTE
See Figure 2-171 (Lightning) or Figure 2-173 (Ulysses). Once
the clamp load has been released on the final fastener securing
the right front module to the upper triple clamp, the left front
module can be removed.
11. See Figure 2-172 . Loosen but do not remove final fastener
securing the right front module to upper triple clamp.
12. See Figure 2-171 (Lightning) or Figure 2-173 (Ulysses).
Remove the left front module.
13. See Figure 2-172 . Remove the final fastener and the right
front module.
2
1
sm03875
1. Left module
2. Right module
Figure 2-171. Front Modules: Lightning
1
2
sm03876
1. Module fastener
2. P-clamp fastener
Figure 2-172. Front Module
HOME
2010 XB Service: Chassis 2-127