http://www.buderus.net
23
Operating and error messages
4.2
Identifying and resetting faults
If a fault occurs, the error code flashes on and off on the
display of the BC10 basic controller.
z
Push the "Reset" button for approx. 5 seconds to reset the
fault.
The display shows "rE" while resetting. Reset is only possible
if there is a flashing error message.
If the display then shows a normal operation message from
table 5, this means that the fault has been remedied. If the
fault recurs, you must repeat resetting two or three more
times.
If the fault cannot be reset:
Write down the error message and contact your heating
equipment servicing company.
Make sure that the heating system is not damaged by frost
(see the safety instructions in chapter “Shutting down the
boiler” on page 18).
