(61) ht Fuse
This fuse is for the high voltage supply for the tubes. Sometimes when a tube goes faulty it will result in
this fuse blowing. A fuse is included because without it, collateral damage could occur that could be even
more inconveniencing. The fuse is located within the cap of the fuse holder. This fuse must be replaced
with one of the same type and value to avoid damaging the amplifier and voiding the warranty. If the amp
repeatedly blows the fuse, it should be taken to a qualified service center for repair.
WARNING: THE FUSE SHOULD ONLY BE REPLACED AFTER THE POWER CORD HAS BEEN
DISCONNECTED.
(62) iec mains connector
This is a standard IEC power connector. An AC power cable having the appropriate AC plug and ratings
for the intended operating voltage is included in the carton. The Power Cable should be connected to the
amplifier before connecting to a suitable AC outlet.
u.s. domestic ac Power cable
The power cable supplied with the unit is a heavy duty, three-connector type with a conventional 120
VAC plug with ground pin. If the outlet used does not have a ground pin, a suitable grounding adapter
should be used and the third wire should be properly grounded.
Never break off the ground pin on any equipment. It is provided for your safety.
NOTE FOR UK ONLY:
If the colours of the wires in the mains lead of this unit do not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows: (1) The wire that is coloured green and
yellow must be connected to the terminal that is marked by the letter E, the earth symbol or coloured
green or green and yellow; (2) The wire that is coloured blue must be connected to the terminal that is
marked with the letter N or the colour black; (3) The wire that is coloured brown must be connected to
the terminal that is marked with the letter L or the colour red.
(63) mains Fuse
This fuse is for the mains supply for the amp. The fuse is located within the cap of the fuse holder. This fuse
must be replaced with one of the same type and value to avoid damaging the amplifier and voiding the
warranty. If the amp repeatedly blows the fuse, it should be taken to a qualified service center for repair.
WARNING: THE FUSE SHOULD ONLY BE REPLACED AFTER THE POWER CORD HAS BEEN
DISCONNECTED.
27
MIDI
In/Foot
Out
Level
Mix
Level
Mix
Level
Impedance
Slave
Out
Mix
Send
Return
Effects Loop 1
Effects Loop 2
Effects Loop 3
Master
Channel
Parallel
4
8
Ohms
16
Series
Full
Half
Tube
T2AH /
HT FUSE
FUSE
250V
Solid
State
Send
Return
Global
Send
Power Amp
In
Pre-Amp
Out
Return
Power
Level
Power
Pan
Level
Speaker Outputs
Speaker Outputs
100W RMS/40V RMS
Total Minimum Speaker Impedance 4
(outputs paralleled)
Designed and
Made In U.S.A.
Built Under U.S.
Patent No. 5,197,102 and
Other Patents Pending
Budda
MN 100
“By Amp Fanatics”
Rectifier
Type
TM
FUSE
FUSE
FUSE
FUSE
62
56
59
60
54
57
55
61
63
58
MN™-100 GUitAr AMplifier
