NOTE: For additional information regarding the parts mentioned in the following
pages, refer to the Assembly Diagram near the end of the manual.
1. Turn the Power Switch off. Then, plug the Power Cord Plug into the nearest
120 volt, grounded, electrical outlet.
2. Connect the Dust Collector to a woodworking machine’s dust port using
appropriate dust collection hoses and clamps (sold separately), then turn the
Dust Collector on. After, turn on the machine.
Only attach this dust collector to a woodworking machine.
3. When finished using the Dust Collec tor turn it off. Unplug the Power Cord
Plug from its electrical outlet. Then store the Dust Collector in a safe, clean,
dry location out of reach of children and unauthorized users.
12
INSPECTION, MAINTENANCE, AND CLEANING
OPERA
TING INSTRUCTIONS
WARNING
!
OPERATING INSTRUCTIONS
DC30A
Always make sure the Power Switch is in its “OFF” position, and unplug
the Power Cord/Plug from its 120 volt electrical outlet before performing
any inspection, adjustments, maintenance, or cleaning.
1. Before each use, inspect the general condition of the Tool. Check for
loose screws, misalignment or binding of moving parts, cracked or
broken parts, damaged electrical wiring, and any other condition that
may affect its safe operation. If abnormal noise or vibration occurs,
have the problem corrected before further use.
Do not use damaged equipment.
2. Daily: With a soft brush, cloth, or vacuum, remove all dust and debris
from the exterior of the Tool.
3. All maintenance, service, or repairs not listed in this manual are only
to be attempted by a qualified service technician.
WARNING
!
CAUTION
!
Summary of Contents for DC30A
Page 12: ...13 DC30A EXPLODED VIEW ...
