3. Test the pawls on your Quick Connect Buckles to ensure they freely rotate and return back to their original
position. If any pawl does not freely rotate, the buckle should be (a) cleaned as outlined below to ensure
there are no obstructions inside the buckle hindering its intended function and (b) lubricated with a
lightweight lubricant such as WD-40
®
as recommended for locking snaphooks. If the pawl still does not
freely rotate, you should contact Buckingham Mfg. at the telephone number outlined below and request a
Returned Goods Authorization Number for immediate return of your harness or Arborists tree saddle for
our inspection and/or buckle replacement.
4. Ensure the receptor end and tab end of the Quick Connect Buckle is fully connected with both locking
pawls engaged. When the two halves are properly attached together, a clicking sound should be heard.
Complete by pulling the adjuster strap through the buckle and tighten until it is snug but comfortable, thus
ensuring complete engagement.
Cleaning:
Proper maintenance and storage of your equipment will prolong its useful life and contribute toward
its performance. The equipment should be cleaned and maintained at regular intervals depending
on usage.
Nylon - Clean with water and mild soap (a dish washing soap that removes grease (i.e. Dawn) and allow
to dry thoroughly without using excessive heat. Do not use any type of corrosive substance or acid,
which will gradually eat away the fabric.
Leather - Using a sponge, wash leather with saddle soap and water, then wipe with a clean damp cloth.
Allow the leather to dry completely - avoid high temperature heat sources. After drying, the leather
should be oiled with 100% Neatsfoot Oil, wiping off any excess with a dry cloth.
Quick Connect Buckle
–
The Quick Connect Buckle may be cleaned by using a cotton swab, limited air
pressure or dipping it into a container of water to remove fine particles and any
foreign matter which may enter the receptor end of the buckle and preventing
proper engagement and function. The exterior of the buckle should be dried
with a clean cloth. The inside of the receptor end of the buckle should be
air-dried and re-lubricated.
Maintenance:
Quick Connect Buckle
–
Lubricate pawls weekly or as often as required to maintain smooth operation (no
binding) with a lightweight lubricant such as WD-40
®
. Wipe any excess lubricant off
with a clean dry cloth.
Storage:
A dirty product should be washed and rinsed in clean water, and then air dried. Do not store near
solvents or corrosive chemicals or at extreme temperatures. Inspect your equipment carefully before
use. This product should be stored in a clean and dry environment out of direct sunlight and away
from extreme climate conditions.
Buckingham's primary concern is to provide a quality product to its customers to enable them to carry out their
profession in a safe manner. However, we always require our customer’s assistance in proper equipment
operation, inspection and maintenance. Should you have any questions regarding equipment manufactured by
Buckingham Manufacturing Co. contact us at 1-800-937-2825.
BINGHAMTON, NY
1-800-937-2825
Information contained in these written instructions supersedes all other information (written, audio, video etc.) produced by Buckingham Mfg. prior to the revision date of this document.
6263 6264Inst.Doc P/N 230305 (Rev. 11/14/2016)
