OX Block Instructions and Warnings (Rev. 5/22/18)
PN 230325
5
BUCKINGHAM MFG.
OX BLOCK
TM
Instructions and Warnings
6.
Always close the faceplate before applying any force or load to the OX BLOCK.
7.
Always ensure the friction bar safety gate is closed before applying any force or load
to the OX BLOCK.
8.
Wear to the friction bar is minimized when ropes are clean and descent speed is
minimized; loads must never be allowed to run or free fall.
9.
Slack must be kept out of the system to prevent high-impact falls.
10.
The OX BLOCK is intended for use by medically fit, specifically trained, experienced
users.
11.
Thorough and specific training is absolutely essential before use. Heights are dangerous.
It is up to you to reduce risks as much as possible, but risks can never be completely
eliminated. There are many ways to misuse this equipment—too many to list or even
imagine. You must personally understand and assume all risks and responsibilities of
using this equipment. If you cannot or do not want to do this, do not use this equipment.
INSPECT BEFORE AND AFTER EACH USE
The inspection should include, but not be limited to the following:
* Check all parts to ensure no corrosion, cracks, deformation, gouges or scratches, rough
areas or sharp edges that may abraid the rope or excessive wear exists.
* That the sideplate rotates normally & the button operates properly.
* The button is not be impaired by dirt, ice, corrosion, etc.
* Swivel / shackle top rotates freely and has no excessive vertical movement.
* The swivel / shackle top bolt is tight and the roll pin used to hold it is in place.
* Shackle Top models: the Nyloc Nut on the hardware attachment Shoulder Bolt is in place
and completely tight.
* Ensure smooth rotation of the sheave and proper operation of the gate.
INSPECT DURING USE
Regularly inspect and monitor OX BLOCK while in use, confirming proper connections,
position, fully locked faceplates and gate, and fully extended buttons.
The OX BLOCK like all equipment must be replaced by the user at regular intervals. This
interval should be dictated by the amount of use and type of service the product receives
rather than a set time frame. Therefore the manufacturer does not place a time limit on
replacement of the OX BLOCK. Due to the rigorous strain the OX BLOCK endures, it should
be replaced at the earliest signs of wear. OX BLOCK inspection is extremely important and
must as a minimum be performed as stated.
If any evidence of wear or deterioration as outlined is observed, immediately cease use,
destroy the product, and replace it with new equipment. Should any unusual conditions
not outlined above be observed or you have reasonable doubt about a particular condition,
remove the equipment from service and notify your Supervisor, Safety Director, or contact
Buckingham Mfg. Co. for clarification.
MAINTENANCE & STORAGE
Clean if necessary with fresh water, then allow to dry completely without using excessive
heat. The button may be cleaned by holding it upside down & spraying a light lubricant into
it while operating it. Store in a dry place away from extremes of heat and cold, and avoid
chemical exposure.
PRINCIPAL MATERIAL
Aluminum alloy, anodized.
REPAIRS OR MODIFICATIONS TO EQUIPMENT
Only Buckingham Mfg. Co. or those people authorized in writing by Buckingham Mfg. Co.
may make repairs / modifications to this equipment. Therefore, do not alter, modify or repair
this product.
WARNINGS
• This equipment is intended for use by properly trained professionals only.
• Manufacturer’s instructions shall be provided to the user of this product. If additional copy
is needed, contact Buckingham Mfg. Co.
• Completely read, understand, and follow all instructions, warnings, and guidelines
pertaining to this and all associated equipment before use. Failure to do so could result in
your serious injury or death.
WARNING:
Thorough and specific
training is absolutely
essential before use.
Always refer to rope
manufacturer’s
instructions and warnings.
