16
3
4
19
7
14
15
PAGE 6 OF 7
Steps 13-17
Instruction # 52819
Step 13:
Slide the cross support
16
onto the bracket on the left leg assembly
3
.
Attach it to the leg assembly with (3) machine screws
4
. Do not fully tighten. Turn
the bottom of the right leg assembly
7
about 1/4 turn counter-clockwise. Insert the
cross support onto the bracket while turning the bottom of the leg clockwise back to
its original position. Attach the cross support to the right leg assembly with (3)
machine screws
4
. Fully tighten all (6) screws in the cross support.
Step 14:
Fully tighten the ferrule screws
13
holding the square steel tube to the
worksurface supports. Fully tighten the (4) wood screws 6 attaching the leg
assemblies
3
and
7
to the worksurface
5
. Fully tighten the (2) or (3) wood screws
6
attaching the square steel tube
12
to the worksurface.
Step 15.
Thread (4) leveler glides
19
into the bottom of the leg assemblies
3
and
7
.
These are in the hardware pack that came with the leg assemblies. Fully tighten.
Step 16:
Plug the switch wire into the round receptacle on the end of the control
box
14
. Plug the motor wire into the rectangular receptacle on the control box.
Make sure it clicks into place. Run the wires through the wire management J
15
.
Step 17:
With the help of an assistant, set the workstation upright in its final
location. Level the workstation in required by turning the glides clockwise (from
the top) on the low corners of the unit.
