Bticino TVCC T9654A, Installation Manual

Page: 7 / 12

7
GB
+ -
4,5mm
26mm
87mm
A
B
A
B
Description
The camera uses a reliable and long-life 1/4” solid state
CCD
colour detector.
It offers excellent picture play back and high heat resi-
stance.
A - 12Vd.c. power supply connector
B
- BNC connector (
VIDEO OUT
)
Features
Power supply 12V d.c. ± 10%
Absorption 80mA
Detector 1/4” colour CCD
Resolution 512 (H) x 491 (V) NTSC // 512 (H) x 581 (V) PAL
Minimum lighting 1 lux /F 2.0
Signal/noise ratio > 48dB (AGC OFF)
Electronic shutter 1/60 (1/50) to 1/100.000 sec.
White balancing AUTO
ALC 3 windows
Output signal 1,0Vpp composite - 75
Ω
Optics mounted f3,6mm/F2.0
Lens angle 70°
Dimensions (mm) 87 x 26mm
Weight 305g
Note
: drawings and specifications are subject to change without notice.
Warnings
- Do not turn the camera towards the sun.
- Do not point the camera towards the sun even if it is not filming.
- Do not film when the light is too bright.
- Install the camera in a place where it cannot get wet. If it gets wet, detach it from the power supply immediately and contact the
after-sales service.
- Install the camera away from video noise sources. When the camera cables are laid near to electrical conductors or antennae
for televisions, there may be interference on the picture. If this happens, reposition the cables or reinstall the device.
- The picture quality may be worsened or some parts inside the camera may be subject to faults, if the ambient temperature is
higher or lower than that indicated in the specifications. The camera should not be used in these circumstances.
- Precautions should also be taken if there is a high degree of humidity.
Connections
Connect the camera ( Video Out ) output to the monitor input terminal
(
Video In
) using a coax cable (75 ohm).
Supply the camera with 12V d.c. ± 10%
- recommended power supply BTicino Item 392100.