Bticino HC4680, Instruction Sheet

Page: 16 / 68

16
To save one or more scenarios:
In the Scenario Module press the
programming enabling pushbutton.
Its led becomes green:
the module is enabled.
ART.F420
DEL
ART.F420
DEL
Press the key to program for more than
four seconds.
When the led lights up release the key.
The led flashes to indicate that the pro-
gramming mode has been activated.
Repeat the sequence to add, edit or cancel a scenario command.
At the end of the programming you should disable the possibility
of editing the scenarios by pressing the Scenario Module (F420)
enable/disable pushbutton. The led becomes red.
Set the sequence of commands which
make up the scenario.
Press the key to end the
programming.
Press the corresponding key to activate
the scenario required.
2.1 Mode of operation
Your Scenario Control can program up to four scenarios, saving them
in a Scenario Module (F420) which has been enabled for programming.
2.1.1 To program a scenario
ON
OFF
ON
OFF
on
on
2 Use
t > 4 s
light cinema
night relax
light cinema
night relax
light cinema
night relax