background image

2

Front and rear view

5

5

*

  

This device does not support standard POE power supplies, but only POE power supplies identified with 375002. 

 

Connect the cat5/5e/6 FTP or cat5/5e/6 UTP cable with ferrite supplied to the connector.

Hereby, BTicino S.p.A., declares that the radio equipment type Indoor unit with camera 7" - 373002 / Indoor unit 7" - 373004 is in compliance with Directive 2014/53/EU. 
The full text of the EU declaration of conformity is available at the following internet address:  www.bticino.it/red

Read carefully before use and keep for future reference

Touching the units with wet hands is forbidden

Using liquid cleaners or aerosols is forbidden

Blocking the ventilation openings is forbidden

Modifying the devices is forbidden

Removing protective parts from the devices is forbidden

Installing the units near liquids and powders is forbidden

Installing the units near heat sources is forbidden

Installing the units near harmful gases, metal dusts or similar is forbidden

Fastening the units on unsuitable surfaces is forbidden

Danger of electrical shock

Risk of devices falling because the surface on which they are installed collapses or inappropriate installation

Switch the power supply OFF before any work on the system

Caution: Installation, configuration, starting-up and maintenance must be performed exclusively by 

qualified personnel.

Check that the wall installation has been carried out correctly

Lay out the wires respecting the standards in force

Connect the power supply wires as indicated

Use only the items indicated in the technical specifications for any system expansions

Remote operation may cause damage to people or property.

Warnings and consumer rights

Configuration

The device must be configured by software. For software download, installation device documentation and for any 
other information, refer to the website.

www.homesystems-legrandgroup.com

1.  Microphone

2.  Camera(only 373002)

3.  Display 7" (touch screen)

4.  Notification LED 

LED flashing= notification of a message

5.  Loudspeaker

6.  SOS push button

7.  Fixing magnets for bracket

8.  USB Connector (not used)

9.  Not used

10.  Additional power supply clamps 

(not polarized)

11.   RJ45 Connector *

12.  Connection clamp

Technical data

Voltage

24 Vdc

Maximum consumption

0.55 A

Max. cable section for clamps

0.8 mm²

Operating temperature

(- 10) – (+ 55)°C

IP degree of protection

IP30

Maximum relative humidity

93%

8

9

10

7

7

11

12

2

4

1

3

6

All contacts must be connected to GND and the corresponding dedicated input. 

The functions and wiring mode of the inputs are set by default as shown in the table and diagram, they can be customized using the software and/or straight from the device. 

Tamper and Doorbell input are not customizable and SOS-GND is disable by default.

560 Ω

560 Ω

GND

contacts from

F1 ÷ F8

GND

SOS

DoorBell

Tamper

Connection clamps

SOS – GND

Additional SOS call

F1 – GND 

Infrared

DoorBell – GND

Door bell call

F2 – GND 

Magnetic contact

Tamper – GND

Tamper

F3 – GND 

Smoke sensor

GND

future use

F4 –GND 

Gas sensor

485-A1

F5 – GND 

Water sensor

485-B1

F6 – GND 

Magnetic contact

GND

F7 – GND 

Magnetic contact

485-A2

F8 – GND 

SOS

485-B2

+12V – GND

12Vdc, maximum 150 mA 

sensor power supply

Reviews: