background image

Wireless Mouse 

無線滑鼠

 M969TUL III EMPREX / BTC

 

 

FCC GUIDELINES  

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions may cause harmful 

interference to radio communications. However, there is no guarantee that interference will not occur in 

a particular installation. If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user is encouraged to try 

to correct the interference by one or more of the following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

 

Use only shielded cables to connect I/O devices to this equipment. 

FCC Warning:

 This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions: (1) this device may not cause harmful interference, (2) this device must accept any 

interference received, including interference that may cause undesired operation. 

FCC Caution: 

Any changes or modifications not expressly approved by the party responsible for 

compliance could void the user's authority to operate this equipment. 

Information to user:  

The users manual or instruction manual for an intentional or unintentional radiator shall caution the user 

that changes or modifications not expressly approved by the party responsible for compliance could 

void the user’s authority to operate the equipment. 

IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. 

End users must follow the specific operating instructions for satisfying RF exposure compliance. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

產品規格:

 

 

Specifications: 

 

 

頻率範圍

: 2402MHz-2479 MHz 

 

滑鼠

Output power:   88.01

 dBuV/m 

 

接受器

 Output power:

  96.22 dBuV/m 

低功率電波輻射性電機管理辦法:

 

第十二條:經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或

變更原設計之特性及功能。

 

第十四條:低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善

至無干擾時方得繼續使用。

 

 

    

前項合法通信,指依電信法規定作業之無線電信。

 

 

 

低功率射頻電機需忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

 

 

 

 

 
 
 

Do not litter 

Summary of Contents for Emprex M969TUL III






Reviews: