COMBO DRIVE
10
Note:
The design of front panel is subject to change without notice.
Rear View
1. Digital Audio Output Connector
If your sound card has a digital audio IEC958 format connector, you
can connect it to this digital audio output connector with a 2-pin audio
cable.
2. Analog Audio Output Connector
This connector allows you to connect the drive to your sound card with a 4-pin
audio cable.
3. Device Configuration Jumper
Set the jumper to Master, Slave or Cable Select according to your
system configuration.
4. IDE Interface Connector
Plug one end of the 40-pin IDE cable here to join the 40-pin IDE
connector on the motherboard. The red-edge of the IDE cable must be
connected to Pin 1 of each connector.
5. Power Supply Connector
By plugging the computer’s power supply cable here, you can connect
the Combo Drive and your computer system.
