9001ARF QIG
英
3100504760 v1.2
9001ARF Wireless Keyboard & Mouse Kit
Quick Installation Guide
Hardware Installation
Slide Switch Setting
1. Make sure your PC is switched off.
2. Take
the
receiver
and select channel CH1 or CH2 by
using the slide switch on the back of the receiver.
(
Remember your selection.
)
CH2
CH1
3. Connect the
receiver
to your PC by plugging in the
receiver’s green connector into the mouse port of your
PC and the purple connector into the keyboard.
4. Take
the
keyboard
and make sure the batteries on the
back are installed correctly. (Follow the polarity signs
in the battery compartment.)
5. Use the slide switch on the back of the
keyboard
to
select the same channel as the one selected in step 2 on
the receiver.
Slide Switch
(-)
Battery 1.5V 2pcs
(+)
ID Button
6. Take the
mouse
and make sure the batteries on the
back are installed correctly. (Follow the polarity signs
in the battery compartment.)
7. Use the slide switch on the back of the mouse to select
the same channel as the one selected in step 2 and 5.
Slide Switch
ID Button
Channel slide switch
1 CH 2
ID Button Setting
ID Button
Slide Switch
ID Button
This ID-recognition function helps to protect against
interference from other RF keyboards in the same
environment. Remember to set the ID when you replace
the batteries or your keyboard kits do not work properly.
The word CONNECT labels the ID button on each unit.
1. Your PC must be on to change the ID setting.
2. Press ID button on the side of the receiver once.
3. Press ID button on the bottom of the mouse once
4. Press ID button on the bottom of the keyboard once.
CH2
CH1
ID Button
Software Installation
Keyboard Driver Installation
In order to take advantage of the special button functionality of the keyboard you will have to install
the keyboard driver which is located on the driver CD included in the box.
1.
Insert the driver CD into your drive.
2. Run
the
SetupKey.exe
in the
\9013RF&9001ARF\keyboard software
directory of the driver CD.
3.
Follow the onscreen instructions to finish the installation procedure.
Mouse Driver Installation
In order to take advantage of the special shortcut button functionality of the mouse you will have to
install the mouse driver which is located on the driver CD included in the box.
1.
Make sure the driver CD is in your drive.
2.
Run the
setup.exe
in the
\9013RF&9001ARF\mouse software
directory of the driver CD.
3.
Follow the onscreen instructions to finish the installation procedure.
Mouse Connector
Keyboard Connector
Bottom View of Mouse
Slide Switch of Setting
ID Button of Keyboard
ID Button of Receiver
ID Button of Mouse
