B
T
P
A
I
N
T
B
A
L
L
.
C
O
M
3
3. Getting Started
R
Riip
p--C
Clliip
p S
Se
ettu
up
p
The Rip-Clip comes with 2 different adapter plates and 2 different
length rail locking screws for use on all TM Series markers.
• Select the adapter plate for your marker, they are labeled either
TM-15 or TM-7.
• Put both screws with thumb nuts attached into the Picatinny rail
locking arm.
• Place the correct adapter onto the Rip-Clip body if needed.
• Install the rail
locking arm with
screws and
thumb nuts onto
the Rip-Clip body
using a flathead
screwdriver (Fig.
3.1).
• Make sure the
screws are fully
seated into the
body.
Battery Installation
• Using a Phillips-
head screwdriver,
remove the screw
on top of battery
door and lift off
door.
• Install (4) AA alka-
line batteries fol-
lowing the polarity
markings (Fig. 3.2).
• Reinstall the door and battery door screw.
N
No
otte
e:: For best results, only
use quality name-brand
alkaline batteries. When
replacing batteries, used
batteries should be recy-
cled.
Rip-Clip Installation
• Loosen up the thumb
nuts (Fig. 3.3).
Fig. 3.1
Fig. 3.2
Fig. 3.3
Rip_Clip_Manual_TM_Series.qxp 1/26/10 3:02 PM Page 3
www.WolfpackPaintballTeam.com
