9
Vehicle starting and Running
If there is a problem with the engine,press engine OFF
After running you must check the car and perform routine
Ma ke s ur e li nk age s etu p i s co r r e ct b e fo r e running.
Turn on transmitter first then the receiver.If you turn on
Make sure you understand all engine instructions before
a t t e m p t i n g t o s t a r t t h e e n g i n e . F a i l u r e t o f o l l o w a l l
instructions can lead to damage to your vehicle, property
damage and bodily injury.
receiver first,it can cause you to lose control the car.
ma in te na nc e.
switch to shut down the engine.
C a ution
the engine.
If there is a problem with the engine,
press engine off switch to shut down
Preparation for Engine Start
keep the wheels off the ground
Fill Fuel Tank
Clean the dirt from gas cap before removing.Dirt and debris
should never get into the fuel tank.Fill the tank with fuel.
Make sure the gas cap is screwed on tightly before starting
the engine.
You m us t us e mi xt ure o f gas o l in e a nd t w o s t ro ke o il a s fu el
for this engine,Never use glow fuels intended for R/C cars.
Caution
Be careful not to tilt the car,gasoline may
leak from the vent hole.
Turn on the transmitter first,then turn on the receiver.
C h e c k t h e t h r o t t l e a n d s t e e r i n g f u n c t i o n a n d c h e c k t h e
radio range before starting the engine,Make sure no one
is using the same frequency.
I f y o u s w i t c h o n t h e r e c e i v e r
you may lose control of the R/C
switch before the transmitter,
car.
Check
Max
.
Range
push
Priming Engine
for the first time,if fuel appears in the yellow
To prime the engine,fill the tank with fuel and
p u s h t h e p r i m e r b u l b u n t i l f u e l a p p e a r s i n t h e
r e t u r n t u b e ( Y e l l o w ) . A f t e r t h e e n g i n e r u n n i n g
return tube,you do not need to prime the engine.
Primer Bulb
PUSH
Return pipe
Out
In
Into the tubing
Turn on remote control power
Engine OFF
Switch
PUSH
TH.TRIM
ST.T
RIM
EXIT
ENT
+
-
ST.D/R
POWER
Multi Function
ON