5
On-Air 2100 Classic ~ 1st Edition ~ Issue 2 ~ 11th November ’02 ~ 5051
Setting up
Please note that your handset is already
registered to the base station.
Situate your product close enough to the
telephone and mains power sockets so that the
cables will reach. The only way to disconnect
the product from the power supply is to remove
the power adaptor from the mains power socket.
Therefore you must ensure you plan the location
so that the mains power is easily accessed.
Make sure it is at least 1 metre away from other
electrical products to avoid interference.
Do not situate the product in the bathroom or
other humid areas.
Once connected, put the plinth back on the
base to prevent it from rocking on the table.
There are two positions for the plinth when
joining it to the base, both can be used for desk
mounting and one for wall mounting. Position
A
is for desk mounting only and position
B
is for
desk or wall mounting (
see Wall mounting on
page 25)
.
Rubber feet
Hold the black plastic square between thumb
and forefinger and peel off individual feet from
backing sheet as shown. These are to stop your
base from moving and to protect your work
surface.
If you decide on position
B
, place 2 of the
rubber feet on the plinth and 2 on the base.
Plan the location
1
Connect the power supply and
switch on.
WARNING
Please take care that the power supply and
telephone line cord are connected to the
correct sockets as incorrect placement could
damage your equipment.
B
A
Important
You must thread the power supply cable into
the socket on the underside of your base. The
power cable connector and socket are
coloured red.
PLINTH
