BT Paintball Rip-Clip, Owner'S Manual

Page: 7 / 16

5
3. Loader Installation.
Insert the loader onto the Rip-Clip as
indicated. Turn the loader Counter-clock-
wise until it locked firmly (Figure 6 - 8).
4. Activating the Rip-Clip.
Locate the power button on the rear con-
trol panel. To turn on, press the button.
The green LED comes on while the button is pressed; now release button. The green LED
will now flash again for one second, go off, then flash quickly 1, 2, or 3 times indicating
the speed it is currently set to. The motor will spin for a second and the loader is now ready
to use. Do
NOT fire your marker until after the initial motor spin has completed. Firing
during this period can disrupt the auto-adjusting sound sensitivity and cause the hopper
not to work properly. The green LED will flash repeatedly while the unit is on to show it is
ready. If the LED flashing changes to red, then the batteries are low and need to be replaced.
To turn off, press and hold until the loader gives a RED indication. Release the button
and loader will power down to the OFF state.
Figure 6 Figure 7 Figure 8
Rip Clip Manual_1.qxp 7/24/07 2:25 PM Page 5